• Name: reflector body reflective marking (with holes)
• specifications: 5 cm * 15 cm
• level: primary color (red and white)
• packaging: the cartons

 According to the ministry of industry and information technology, a truck with a total mass of more than 12 tons and a trailer with a length of more than 8 meters should be equipped with a rear end plate that conforms to the national standard., the van and the van should be equipped with the reflective markers that meet the requirements. The new type of passenger car will be set up from March 1, 2012.And goods vehicles should meet the above requirements; As of September 1, 2012, the above mentioned passenger cars and trucks shall meet the above requirements.

Use materials: domestic raw materials, imported special reflector type.

Performance: excellent positive brightness and Angle performance. In the case of the incident Angle of 89 degrees, it can still achieve a good reflective effect.

Durability: strong.

Material: PMMA

Grade: level 1
Performance:
It is wear-resistant, scratch-resistant, impact resistant, water resistant, gasoline, diesel and other solvents.
The product has super reflective performance, good wide Angle performance.
Good flexibility, easy construction.
The unique design of the back adhesive has the characteristics of strong strength, low temperature resistance, non-corrosive paint surface and repeated paste.
Has good resistance to weathering, under the condition of ℃ and 40 ℃ - 70 performance as usual, the service life of seven years

Product introduction:

This product adopts the most advanced mould manufacturing technology in Japan, and it still has super-strong recovery reflex in the big Angle, and its anti-reflection performance in different angles.Better than the state. This product is our company's patented product, is the only one in the country to accord with the big Angle return double reflex performance first product.

The product has been tested by the national automobile quality supervision and inspection center. Comply with national standards gb11564-2008 \"motor vehicle recovery reflector.\"And the relevant provisions of GB 23254-2009 \"reflective identification of truck and trailer body\".